Overall Rating:
4.8 / 5
4.8 / 5
4 of 4(100%)would recommend this product to a friend.
Share this Product:
Facebook Digg DelIcioUs Twitter MySpace
Review This Product
Overall Rating:
4 / 5
4 / 5
Tailgate saver,
July 13, 2009
By VolvoTech
from Waterford, MI
Reviewer Images
(click to see full-size image)
User submitted photo
User submitted photo
"At last I can connect my 5th wheel trailer plug inside the bed instead of draping the cable over the tailgate and down to the bumper. The locking tab on the harness connector was a little too long (can't push the factory plug in deep enough to engage the lock), so I just trimmed a little off with a box cutter. The 7-way socket is a little lightweight. I wound up replacing it with a combo 7 round/4 flat socket so I could install some "bling" lights on my toolbox and plug them into the 4 pin connector. Overall, I'm happy with the purchase."
What is your level of technical expertise? Professional
Share this Review:
Facebook Digg DelIcioUs Twitter MySpace
Overall Rating:
5 / 5
5 / 5
EASY,
August 11, 2008
By TOBY5181
from WV
"IT WAS A EASY INSTALL. BUT AFTER SOME TIME THE HARNESS LOST CONNECTION AND THE LOCK TAB BROKE. I PUT A ZIP TIE AROUND THE PLUG AND PROBLEM FIXED."
What is your level of technical expertise? Professional
Share this Review:
Facebook Digg DelIcioUs Twitter MySpace
Overall Rating:
5 / 5
5 / 5
Valley Industries wiring harness,
April 14, 2008
By randyw
from Sturgis,Ms.
"After searching the internet for some time, I found the exact part I was looking for on northerntool.com. I needed a wiring harness for my 2005 2500HD truck that didn't involve any cutting or splicing. This part is truly "Plug and Play" and the fit was very good. Easy instructions and a high quality part. The " Valley Industries" plug in harness is worth every penny! Thanks for the quick service."
What is your level of technical expertise? Beginner
Share this Review:
Facebook Digg DelIcioUs Twitter MySpace
Overall Rating:
5 / 5
5 / 5
Owner Operator Bobcat Services,
July 9, 2007
By Bobcat911
from Oxford, Ohio
"Money well spent - Easy to follow directions, plenty of wire to reach the front of a long bed if necessary. You will need an exact size hole saw( I think it's a 2 1/8") to drill through the bed wall to mount the receiver. Good quality- Nice fit & finish."
What is your level of technical expertise? Professional
Share this Review:
Facebook Digg DelIcioUs Twitter MySpace