Overall Rating:

4 / 5

Tailgate saver,

July 13, 2009

By VolvoTech

from Waterford, MI

(read all my reviews)

Reviewer Images

(click to see full-size image)

"At last I can connect my 5th wheel trailer plug inside the bed instead of draping the cable over the tailgate and down to the bumper. The locking tab on the harness connector was a little too long (can't push the factory plug in deep enough to engage the lock), so I just trimmed a little off with a box cutter. The 7-way socket is a little lightweight. I wound up replacing it with a combo 7 round/4 flat socket so I could install some "bling" lights on my toolbox and plug them into the 4 pin connector. Overall, I'm happy with the purchase."

What is your level of technical expertise? Professional

Was this review helpful to you?YesYesNoNo(Report Inappropriate Review)(Report Inappropriate Review)

Share this Review:

Overall Rating:

5 / 5

EASY,

August 11, 2008

By TOBY5181

from WV

(read all my reviews)

"IT WAS A EASY INSTALL. BUT AFTER SOME TIME THE HARNESS LOST CONNECTION AND THE LOCK TAB BROKE. I PUT A ZIP TIE AROUND THE PLUG AND PROBLEM FIXED."

What is your level of technical expertise? Professional

Was this review helpful to you?YesYesNoNo(Report Inappropriate Review)(Report Inappropriate Review)

Share this Review:

Overall Rating:

5 / 5

Valley Industries wiring harness,

April 14, 2008

By randyw

from Sturgis,Ms.

(read all my reviews)

"After searching the internet for some time, I found the exact part I was looking for on northerntool.com. I needed a wiring harness for my 2005 2500HD truck that didn't involve any cutting or splicing. This part is truly "Plug and Play" and the fit was very good. Easy instructions and a high quality part. The " Valley Industries" plug in harness is worth every penny! Thanks for the quick service."

What is your level of technical expertise? Beginner

Was this review helpful to you?YesYesNoNo(Report Inappropriate Review)(Report Inappropriate Review)

Share this Review:

Overall Rating:

5 / 5

Owner Operator Bobcat Services,

July 9, 2007

By Bobcat911

from Oxford, Ohio

(read all my reviews)

"Money well spent - Easy to follow directions, plenty of wire to reach the front of a long bed if necessary. You will need an exact size hole saw( I think it's a 2 1/8") to drill through the bed wall to mount the receiver. Good quality- Nice fit & finish."

What is your level of technical expertise? Professional

Was this review helpful to you?YesYesNoNo(Report Inappropriate Review)(Report Inappropriate Review)

Share this Review: