Overall Rating:
4.6 / 5
4.6 / 5
7 of 7(100%)would recommend this product to a friend.
Share this Product:
Facebook Digg DelIcioUs Twitter MySpace
Review This Product
Overall Rating:
5 / 5
5 / 5
Nice product, easy to install,
July 13, 2009
By JoeyVegas
from Las Vegas
"Nice product, easy to install. Can't beat the price. The caps fit tight, but installed easily with a piece of exaust tubing that I had lying around."
What is your level of technical expertise? Professional
Share this Review:
Facebook Digg DelIcioUs Twitter MySpace
Overall Rating:
4 / 5
4 / 5
great product,
November 18, 2008
By chimichanga
from cape cod
"This is a good quality product. It comes all assembled and greased. All you have to do is put it on the axle. I had no problems."
What is your level of technical expertise? Home Handyman
Share this Review:
Facebook Digg DelIcioUs Twitter MySpace
Overall Rating:
5 / 5
5 / 5
Great value,
October 28, 2008
By Hitchman
from Virginia
"These hubs are a great value, the bearings are pregreased and the entire hub is ready to install on your spindle. The dust cap is not a problem to install if you are smarl enough to figure out that a short section of 2" water pipe makes a great installation tool."
What is your level of technical expertise? Professional
Share this Review:
Facebook Digg DelIcioUs Twitter MySpace
Overall Rating:
4 / 5
4 / 5
Great hubs,
April 23, 2008
By FozzyBear
from Colorado
"Hubs are well made and easy to install. Not having to pack grease is a BIG plus. Bearing cover is a VERY tight fit. Both covers ended up being dented badly. Not a deal breaker, but the covers are concave now rather than convex."
What is your level of technical expertise? Professional
Share this Review:
Facebook Digg DelIcioUs Twitter MySpace
Overall Rating:
4 / 5
4 / 5
Easy to install,
January 26, 2008
By astatefan1
from Jonesboro, AR
"These hubs were very easy to install, and since they are pre-greased, they created less mess. The only complaint I had is that the dust caps were very hard to get on. I didn't have a pipe or sleeve the right diameter to slip over the cap and actually have the impact point on the flange, so I ended up denting the end of the cap pretty bad."
What is your level of technical expertise? Home Handyman
Share this Review:
Facebook Digg DelIcioUs Twitter MySpace
Overall Rating:
5 / 5
5 / 5
HUB,
January 14, 2008
By RudyZ
from Eagle Pass, Texas
"Good product. Easy to assemble when accompanied by their corresponding hub axle. Would recommend for anyone."
What is your level of technical expertise? Home Handyman
Share this Review:
Facebook Digg DelIcioUs Twitter MySpace
Overall Rating:
5 / 5
5 / 5
hubs,
October 17, 2007
By bldegle
from Pierce, ID
"Hubs came with all the grease and fittings. No messy hands from trying to get bearings hand greased. Eveything went together somoohtly."
What is your level of technical expertise? Professional
Share this Review:
Facebook Digg DelIcioUs Twitter MySpace