Top Rated Product

Product Reviews

ProCom ProCom Base for Vent Free Heaters, Model# PF09B

For use with vent free heaters over 10,000 BTU. Pair of base legs that are attached on each end of heater with two sheet metal screws. Dimensions per leg: 12in.L x 4in.W x 2in.H

Average Customer Rating:

4.3 out of 5

13 of 14 (93%) customers would recommend this product to a friend.

Customer Reviews for ProCom Base for Vent Free Heaters, Model# PF09B

FEATURED REVIEW

Overall Rating:

5 / 5

A Very Fine Heater at a Good Price, March 7, 2007
By outafocus from San Antonio, Texas

"I bought a similar heater that cost me twice as much money ten years ago. It was very good, and gave me just a few minor problems over the years. It finally gave up the ghost on one of the coldest days this past winter, and I scurried to find another one. I couldn't find one anywhere. Thanks to the Internet, I found Northern Tools sold a similar heater, and I was shocked that the price was so low. I ordered it online, and was pleasantly surprised when it was delivered. It was MUCH nicer than the one it replaced, both aesthetically, and in workmanship. When I fired it up, I was amazed at the better heat distribution this unit had over my old one.

I heartily recommend the ProCom heater."

What is your level of technical expertise?: Home Handyman

Review 2 for ProCom Base for Vent Free Heaters, Model# PF09B

Overall Rating:

3 / 5

Stand for LP unvented gas heater, August 11, 2008
By Wibb from CT

"The stand (feet) for the stove were fine with one exception: you can't follow the instructions for set up of the stove because the feet don't lift the stove high enough off the floor. My installer solved the problem by ignoring the instructions to make a water/dirt trap in the plumbing of the heater. Either the instructions need to be changed, or the stand needs to be higher."

What is your level of technical expertise?: Home Handyman

Review 3 for ProCom Base for Vent Free Heaters, Model# PF09B

Overall Rating:

4 / 5

rhe4x4, April 15, 2008
By rhe4x4 from WV

"It does the job well but could have been better if it were metal."

What is your level of technical expertise?: Home Handyman

Review 4 for ProCom Base for Vent Free Heaters, Model# PF09B

Overall Rating:

4 / 5

ProCom Base for Vent Free Heaters, April 15, 2008
By AndyH from Champaign, IL

"These "feet" for the heater work just fine and are easy to attach. If you aren't going to wall-mount the heater, I'd say they are required."

What is your level of technical expertise?: Home Handyman

Review 5 for ProCom Base for Vent Free Heaters, Model# PF09B

Overall Rating:

2 / 5

ProCom Base for Vent Free Heaters, Model# PF09B, April 15, 2008
By Bucks from Pennsylvania

"THE BASE IS TWO CHEAP PLASTIC FEET WITH NO MOUNTING HARDWARE OR INSTRUCTIONS DETAILING HOW TO ATTACH OR POSITION THEM. NOT WORTH THE MONEY, YOU CAN MAKE YOUR OWN."

What is your level of technical expertise?: Home Handyman

Review 6 for ProCom Base for Vent Free Heaters, Model# PF09B

Overall Rating:

5 / 5

Procom Base for vent free heater, April 14, 2008
By josigi from Ocilla, GA

"I work for my brother who is a paint contractor. We paint new homes and in the winter it can get rather cool in the house.

In new houses when we are painting I can easily move it from room to room and keep that area warm.

I also use the heater in my shop but did not want to mount it so I got the bases so it could be portable. I have used in my shop with great results. The heater stays level and is not easily turned over."

What is your level of technical expertise?: Professional

Review 7 for ProCom Base for Vent Free Heaters, Model# PF09B

Overall Rating:

4 / 5

Good Heater, April 14, 2008
By WillardP from Southern Wisconsin

"Purchased this heater this winter for my 920 sf garage. Easy to use, does a great job."

What is your level of technical expertise?: Home Handyman

Review 8 for ProCom Base for Vent Free Heaters, Model# PF09B

Overall Rating:

5 / 5

Propane Heater, January 18, 2008
By archangel from Michigander

"Found the heater to be as advertised & everything I expected, and more. Installation was simple & I was standing in a warmed garage in about an hour. Thanks for the quality provided."

What is your level of technical expertise?: Home Handyman

Review 9 for ProCom Base for Vent Free Heaters, Model# PF09B

Overall Rating:

5 / 5

Heater Base, January 16, 2008
By Toolen from Loveland, Colorado

"Great product easy to mount on the heater.
Very stable with the feet"

What is your level of technical expertise?: Home Handyman

Review 10 for ProCom Base for Vent Free Heaters, Model# PF09B

Overall Rating:

5 / 5

Nice and warm, January 16, 2008
By jb19 from Northern Ontario

"Looks nice and also works very well. Heat output is very warm... has the ability to keep our 900 sq ft home warm in the Canadian winter if run on its own."

What is your level of technical expertise?: Home Handyman

Review 11 for ProCom Base for Vent Free Heaters, Model# PF09B

Overall Rating:

3 / 5

Heater base, January 14, 2008
By daramire from New Mexico

"We purchased 3 of bases to go with our 3 heaters, they do a good job of stablizing the heater, however I think they could be a little taller, we did have to place the base on concrete blocks to raise it higher becasue of how the unit connects in the back, but the feet do stabilize the heater better than if we just used the bricks alone, overall very satisfied."

What is your level of technical expertise?: Home Handyman

Review 12 for ProCom Base for Vent Free Heaters, Model# PF09B

Overall Rating:

5 / 5

Need the base, January 14, 2008
By Shoptech from Walton, NY

"If you don't hang the heater on the wall, then you will need the base to stand your heater on. The heater works great and keeps both back rooms warm."

What is your level of technical expertise?: Professional

Review 13 for ProCom Base for Vent Free Heaters, Model# PF09B

Overall Rating:

5 / 5

Nice product, January 14, 2008
By f100jetmech from Chiloquin, OR

"These base pieces are a must for the heater if you plan on using it as a free standing unit not mounted on a wall. The propane inlet is on the bottom of the heater and you need at least 1 1/2" of clearance for the propane hook up on the bottom."

What is your level of technical expertise?: Home Handyman

Review 14 for ProCom Base for Vent Free Heaters, Model# PF09B

Overall Rating:

5 / 5

Base for heater, March 7, 2007
By Lininoregon from Eugene Oregon

"I didn't have any trouble putting the base on and it sits real study. I just read the instructions and they were short and it worked just fine. It looks good too. So instead of mounting the heater on the wall (because heat rises anyway) it sits in the livingroom and takes up very little space."

What is your level of technical expertise?: Beginner