"Before buying I read all of the customer reviews and was glad I did. My need for the cart was to carry firewood from my outside quonset to my basement. I had to be able to easily fill and wheel it about fifty feet and walk it down 6 concrete steps. Here are my comments good and bad.
Rust and finish- The cart does come unfinished and is rusty in spots. Prime and paint prior to assembly. Enough high quality Rust-oleum paint will cost you about $15. The paint will get knicked up so attach a piece of quarter inch plywood (17.5" x 17.5") to the bottom of the stacking area. You will have to position the board and drill your own holes. Then cover the inside of the stacking area with a plastic runner by attaching using the front and back plate bolts.
Directions- These leave a lot to be desired. I assembled this myself without much difficulty. However, from the parts list (how many people know what a M6x40 bolt is?) to the assembly, should be rewritten. My kingdom for a good technical writer who writes directions! Study the diagram and rely on it more than the step-by-step. Hint: Read and remember the note "Do not completely tighten screws until the assembly is completed". Especially the eight bolts holding the back plate and the frame pieces.
Design- (1) Add a pair of 1" round heavy duty rubber leg pads to the bottom most part of the lower frame where it comes into contact with the ground, and your floor. Once again you will have to drill your own holes. Use the kind of pad that has a counter sunk center hole with 3/4 inch sheet metal screws. This will protect your floor as well as protect the cart from wear. (2)The way the wheels fit over the axle is sloppy. They wobble back-and-forth because of the play in the hub. A fitted bushing to tap over the axle would be much better. This is my biggest concern for longevity. Only time will tell. Add some grease to the axle before putting on the wheels.
Even with all of the extra work I did in modifications I would buy it again. Ninety five percent of my heat comes from my wood stove and I burn about three cords a year. It has reduced my handling of the wood by 75%."
What is your level of technical expertise? Home Handyman